Primitive Technology: Cord drill and Pump drill

I made a cord drill and then upgraded it to a pump drill. A cord drill is basically a spindle with a fly wheel attached so it looks like a spinning top. the middle of a piece of cord is then put into a notch at the top of the spindle. The ends of the cord are then wrapped around the spindle and then pulled quickly outwards causing the drill to spin. The momentum of the fly wheel causes the cord to wrap back around the spindle in the other direction. When it stops the cords are pulled outwards again and the drill spins in the other direction. I made the first one with a stone flywheel then made fire with it in the same way I make fire with fire sticks. Then I made and fired some clay fly wheels, made another drill with one of the fly wheels and fitted a stone drill bit to the end. This one

It's only fair to share...Tweet about this on TwitterShare on FacebookShare on TumblrShare on Google+Digg thisShare on LinkedInPin on PinterestShare on VKShare on RedditPrint this pageEmail this to someone
Flattr the authorShare on StumbleUponShare on YummlyBuffer this page

Leave a Reply

Your email address will not be published. Required fields are marked *